Stereo Line Module - Harrison 950mx Overview

5.0 Stereo Line Module

Insert Point - Line-level insertion point for an external device. The Insert is always driven and is
pre fader and tone controls.
Filters - HP Filter (100Hz - 12dB/Octave), LP Filter (10kHz - 12dB/Octave)
The filters are not affected by the TONE IN switch.
EQ Controls - HIGH (+ -15dB - 10kHz center), MID (+ - 15dB - 4kHz center), LOW (+ - 15dB -
100Hz center). The IN switch inserts the TONE controls into the signal path. The EQ IN switch
does not affect the HP and LP filters.
Balance Control - Deviates the stereo signal to the left and right mix busses. Unity gain at center,
fully positioned to the left or right gives +3dB.
Stereo Input Section - Level knob controls the stereo line input trim from + - 10dB. L > places the
left input to both the left and right sides of the stereo channel. < R places the right signal on both
the left and right sides of the stereo channel. LR together reverses the left and right inputs to the
stereo channel. MONO combines the left and right signals to both sides of the stereo signal.
Auxiliary Sends - Aux level control for mono sends 1-2 and for stereo send Aux 3L and 4R.
Jumper options are available on the module for pre or post fader settings. The level control has a
range from mute to unity gain.
Channel ON - Enables the channel VCA. The LED switch is illuminated when the channel is ON.
SOLO - The solo signal is derived after the fader. Selecting SOLO assigns the channel to the solo
bus. To listen to the solo bus the SOLO switch must be selected on the Control Room Monitor
module.
Stereo Fader - The 104mm linear travel fader carrying DC control voltage is used to vary the main
signal level from mute to +12dB.
Stereo Mix Bus Routing - Stereo Mix Bus routing switches 1 and 2 send post fader and pan
switches to either or both stereo mix busses provided. The "RED" bus (1) provides a transformer
balanced output stage while the "BLACK" bus (2) provides an electronically balanced output stage.
Input Meter - The four segment input meter is directly after the input section pre EQ and fader and
is a sum of the left and right inputs.
950mx analog console overview v1.5 Page 9