Leak Testing Instructions; Table Top Use - Napoleon PTSS165 Installation And Operating Manual

Table Top Use

The PTSS165 has been designed with mobility in mind. With collapsible legs, the PTSS165 can be set up on
most table tops. The legs fold out and lock into place, folding back into a locked position when on the go. To
use on a table top, unfold the (4) legs located in each corner of your grill.
WARNING!
Ensure the propane cylinder is hanging vertically over the side of the table as illustrated.
WARNING!
Do not use the grill on plastic, resin or glass table tops

Leak Testing Instructions

WARNING!
A leak test must be performed annually and each time a cylinder is hooked up or if a part
of the gas system is replaced.
WARNING!
Never use an open flame to check for gas leaks. Be certain no sparks or open flames are
in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, damage to
property, serious bodily injury, or death.
Leak testing: This must be done before initial use, annually, and whenever any gas components are replaced
or serviced. Do not smoke while performing this test, and remove all sources of ignition. See Leak Testing
Diagram for areas to check. Turn all burner controls to the off position. Turn gas supply valve on.
Brush a half-and-half solution of liquid soap and water onto all joints and connections of the regulator, hose,
manifolds and valves.
Bubbles will indicate a gas leak. Either tighten the loose joint or have the part replaced with one recommended
by the Napoleon Customer Care department and have the grill inspected by a certified gas installer.
If the leak cannot be stopped, immediately shut off the gas supply, disconnect it, and have the grill inspected
by a certified gas installer or dealer. Do not use the grill until the leak has been corrected.
5
www.napoleongrills.com