Prepare Threaded Rods - LG DYNAMIC V8 VL SERIES Installation Manual

Air cleaner
Table of Contents

Advertisement

Air Cleaner Installation
18.
Remove the white protective backing from one of the strips and expose the ad-
hesive.
19.
Beginning at the outside corner of the plenums end/side panel edge, align the
end of the tape strip to the outside corner of the plenum. Align the long edge of
the tape with the duct opening. Alignment along the duct opening should not al-
low folding the aluminum tape around the outlet opening edge.
20.
Next, fold the remaining width of the tape around the side edge panel seam and
securely fasten the tape to the end panel surface. When complete, about two-
thirds of the tape will be adhered to the end panel and one fourth of the side
panel.
21.
Next, fold the remaining 2-inch fl ap of tape over the end/top panel edge and se-
curely adhere about 3/4 of the tape to the top panel surface.
22.
Lastly, fold the remaining tape around the top/front panel edge and affi x the tape
to the side panel surface. The hole in the inside corner of the plenum should now
be covered.
23.
Repeat steps 7-22 for three other edges on the plenum.
24.
Next, attach the four hanger brackets to the end panels of the housing. Begin
by sliding the square-shaped tab on the back of the bracket through the square
hole. Line up the round hole of the bracket to that in the end panel and insert the
bolt provided through the hole and place the lock/nut on the back with the tooth
washer facing the bracket and plenum wall. Hand tighten the nut. Repeat this
process for the other three brackets.
25.
Tighten the four bracket mounting bolts to approximately 15 ft-lbs. Using a ham-
mer, and a wooden block as a backer, thoroughly fl atten the tabs on the back of
each bracket tightly against the end panel inside surface.

Prepare Threaded Rods

1.
Measure and note the location of the threaded-rod hangers on the air
cleaner and return air plenum. Refer to the cut sheets for dimensional informa-
tion.
2.
Using the plan developed earlier, carefully mark the mounting points of the hang-
er rods on the structural support member or surface chosen above the unit.
3.
Following the hanging rod and mounting channel manufacturers' instructions,
mount threaded-rod anchors as appropriate from the hanging surface or channel.
Be sure to select anchors that are rated to support the anticipated weight of con-
nected components.
LG Electronics U.S.A. Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp./www.lghvac.com
30 | Air Cleaner Installation
For continual product development, LG reserves the right to change specifi cations without notice.
Dynamic V8 Air Cleaner

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents