General Planning
Required Parts and Tools
Installing a Dynamic V8 requires the following tools (not including those needed for
fi eld-fabricated ducting):
•
Ball peen hammer
•
Carpenter level
•
Crescent wrenches
•
Drill bit sized for the threaded-rod anchor
•
Face shield
•
Hammer drill or impact driver
•
Nut driver
•
Round wire brush
•
Rubber mallet (for plenum assembly)
•
Screwdriver
•
Socket wrenches
•
Thermometer
•
Torque wrench
In addition to the parts that come with the air cleaner, each installation may require
these parts or consumables:
•
2" x 4" x 6" wooden block
•
Beam clamps
•
Duct clamps
•
Duct tape
•
Duct wrap or insulation
•
Electrical tape (for marking drill-hole depth)
•
#8 Self-tapping screws
•
Sheet metal for duct fabrication
•
Steel channel with mounting accessories
•
Threaded rod anchors
•
Threaded rods, including nuts, fl at washers, and spring washers
General Planning
Before starting the installation, consider the following:
•
Ensure the entire confi guration and installation, including the attached indoor unit,
is carefully planned prior to installation. In some cases, the location of the indoor
unit itself may be affected by the chosen air cleaner confi guration.
•
If the overhead plenum height is suffi cient, employ standard- or mixed-profi le con-
fi gurations as they are the most economical choices. Reserve low-profi le confi gu-
rations for restricted height plenum applications.
•
Identify and plan the layout of all fi eld-fabricated ducting prior to mounting.
LG Electronics U.S.A. Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp./www.lghvac.com
26 | Air Cleaner Installation
For continual product development, LG reserves the right to change specifi cations without notice.
Dynamic V8 Air Cleaner