Electrical Characteristics
The operating voltage of the TM-T88IV is DC24 ± 7%, the same as the TM-T88III. The current
consumption differs depending on the print duty.
DIP Switches
The functional assignments of DIP switches are the same as those of the TM-T88III. With the
same settings as for the TM-T88III, the same functions are enabled for the TM-T88IV.
Printer Status
The TM-T88IV goes to the same status under the same conditions as the TM-T88III. You can
replace the TM-T88IV with the TM-T88III without modifying applications.
Hexadecimal Dumping
Command operation during hexadecimal dumping
During hexadecimal dumping, most commands do not function.
• TM-T88IV: Only DLE EOT functions.
• TM-T88III: Only DLE EOT, DLE ENQ, and DLE DC4 function.
For detailed information about ESC/POS commands, see the ESC/POS Application
Programing Guide.
Ending hexadecimal dumping
After the hexadecimal dumping, the TM-T88IV performs autocutting (partial cut), but the
TM-T88III does not.
Logo Registration
The TM-T88IV can register logos in the NV memory (NVRAM) with the TM Flash LOGO Setup
Utility for NVRAM (TM-Flogo) as can the TM-T88III.
Chapter 5 Replacement of
73
5