Motorola AP-7131 Series Installation Manual page 34

28 AP-7131 Series Access Point: Installation Guide
b. Select the
the correct country code on the first login. A warning message also displays stating an
incorrect country setting may result in illegal radio operation. Selecting the correct
country is central to legally operating the access point. Each country has its own
regulatory restrictions concerning electromagnetic emissions and the maximum RF
signal strength that can be transmitted. To ensure compliance with national and local
laws, set the country accurately. CLI and MIB users cannot configure their access point
until a two character country code (for example, United States - us) is set. The US version
of the AP-7131N only has "US" on the country Selection list.
c. Optionally enter the IP address of the server used to provide system time to the access
point within the Time Server field. Once the IP address is entered, the access point's
Network Time Protocol (NTP) functionality is engaged automatically.
d.
Define a primary and alternate WIPS server IP Address for WIPS Server 1 and 2. These are the
addresses of the primary and secondary WIPS console server. WIPS support requires a Motorola
AirDefense WIPS Server on the network. WIPS functionality is not provided by the access point
alone. The access point works in conjunction with the dedicated WIPS server(s).
NOTE
4. Refer to the new
by the access point's radio(s). Remember, the options available depend on the single, dual
or three radio model SKU deployed.
NOTE
The Quick Setup screen on the previous page displays the Radio Configuration field with all
8 radio button options available. This is only the case with three radio access point SKUs. A
dual radio model access point would display 7 of the eight possible configuration options
and a single radio model would display 4. Refer to the following table for the options
available to single, dual and three radio models.
Country for the AP-7131's country of operation. The access point prompts for
The System Name and Country are also configurable within the
Settings screen. Refer to the AP-7131 Series Product Reference Guide to
optionally set a system location and admin email address for the access
point or to change other default settings.
Radio Configuration
If using a three radio model AP-7131N access point, the radio three
configuration option could be rendered unavailable if Rogue AP detection
is enabled, or if the power source cannot provide adequate power for the
third radio.
field to define how WLAN and WIPS are supported
System