Motorola AP-7131 Series Installation Manual page 14

8
AP-7131 Series Access Point: Installation Guide
A separate Power Injector is required for each access point comprising the network.
The Power Injector can be installed free standing, on an even horizontal surface or wall mounted
using the power injector's wall mounting key holes. The following guidelines should be adhered to
before cabling the Power Injector to an Ethernet source and an access point:
• Do not block or cover airflow to the Power Injector.
• Keep the Power Injector away from excessive heat, humidity, vibration and dust.
• The Power Injector isn't a repeater, and does not amplify the Ethernet signal. For optimal
performance, ensure the Power Injector is placed as close as possible to the data port.
CAUTION
To install the Power Injector to an Ethernet data source and an access point:
CAUTION
To avoid problematic performance and restarts, disable POE from a
wired switch port connected to an access point if mid-span power
sourcing equipment (PSE) is used between the two, regardless of the
manufacturer of the switch.
Ensure AC power is supplied to the Power Injector using an AC cable
with an appropriate ground connection approved for the country of
operation.