Appendix - Fisher FSPI-091B Operating And Installation Instruction Manual

DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual
11.5.7 Test Running
Evaluation of the Performance
Check the voltage of the main electrical wire.
Use a thermometer to measure both inlet and outlet cool air.
The difference between inlet air and outlet air temperature
should not be less than 8°C .
The unit has the function of auto-restart and it can remember
the running mode before power failure.
Be sure to use the exclusive accessories listed above in the installation instructions, or it may result in water
leakage, electric shock, fire, etc.

12. Appendix

Air conditioner nominal working condition and working range:
Test condition
Nominal cooling
Nominal heating
Rated cooling
Low temp cooling
Rated heating
Low temp heating
Note:
● The design of this unit conforms to the requirements of EN14511 standard.
● The air volume is measured at the 0Pa external static pressure.
● Cooling (heating) capacity stated above is measured under nominal working conditions corresponding
to 0Pa external static pressure. The parameters are subject to change with the improvement of products, in
which case the values on the nameplate will prevail.
● In this table, the outdoor side DB temperature of low temp cooling include two values,the one in the
bracket is the working condition of the appliance with function of low temp cooling.
Indoor side
DB(℃ ) WB(℃ )
27
20
32
21
27
20
This product must not be disposed together with the
domestic waste. This product has to be disposed at
an authorized place for recycling of electrical and
electronic appliances.
56
Fig.70
DB(℃ )
19 35
—
7
23 48
15 18(-15)
—
24
— -7
Outdoor side
WB(℃ )
24
6
—
—
18
-8