Sony PMW-160 Operating Instructions Manual page 89

Solid-state memory camcorder
Hide thumbs Also See for PMW-160:
Table of Contents

Advertisement

OTHERS
Menu items
Subitems and setting values Contents
Hours Meter
Hours (Sys)
Displaying the
Hours (Reset)
hours meter
Reset
Execute/Cancel
IR Remote
On / Off
Activating/
deactivating the
Remote
Commander
Battery Alarm
Low BATT
5% / 10% / 15% / ... / 45% /
Setting the low
50%
power alarm
BATT Empty
3% to 7% (3%)
DC Low Volt1
11.5 V to 17.0 V (11.5 V)
DC Low Volt2
11.0 V to 14.0 V (11.0 V)
Battery INFO
Type
Showing
MFG Date
information
Charge Count
regarding the
battery pack
Capacity
(display only)
Voltage
Remaining
Genlock
H Phase (HD)
–999 to +999 (±0)
Setting Genlock
operation
H Phase (SD)
–99 to +99 (±0)
Direct Menu
All / Part / Off
Setting the Direct
menu function
Trigger Mode
Internal / Both / External
Setting for
operating an
external recording
device connected
via the i.LINK
connector (FAT
only)
[M]
The non-resettable accumulated time of use is displayed.
The resettable accumulated time of use is displayed.
Select "Execute" to reset the Hours (Reset) value to 0.
Set to "On" to activate remote control operations from the
supplied IR Remote Commander.
Note
The setting automatically returns to "Off" when the
camcorder is turned off.
Set the battery level at which the Low BATT warning is
generated (in steps of 5%).
Set the battery level at which the BATT Empty warning is
generated.
Set the DC IN voltage at which the DC Low Volt1 warning is
generated.
Set the DC IN voltage at which the DC Low Volt2 warning is
generated.
The type (product name) is displayed.
The date of manufacture is displayed.
The accumulated number of times of charge/discharge is
displayed.
The estimated total capacity of full charge is displayed.
The current output voltage is displayed.
The current remaining level is displayed.
Set the H phase (phase of the horizontal sync signal) of HD
signal for Genlock operation.
Set the H phase (phase of the horizontal sync signal) of SD
signal for Genlock operation.
All: All Direct menu operations are permitted.
Part: A part of Direct menu operations is permitted. The
operation is limited depending on the GAIN, SHUTTER,
or WHITE BAL switch setting.
Off: No Direct menu operation is permitted.
Internal: To activate recording start/stop operations only for
an SxS memory card in a built-in slot.
Both: To activate recording start/stop operations both for an
SxS memory card in a built-in slot and the external
recording device connected via the i.LINK connector.
External: To activate recording start/stop operations only for
the external recording device connected via the i.LINK
connector.
Setup Menu List
89

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pmw-150

Table of Contents