Set Lock Code - JVC AV-65WP94 User Manual

Initial Setup

Set Lock Code

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes
preset with a lock code of "0000". You may change the code to any four-digit number you wish.
To change the lock code, follow the steps below.
Press the M
π †
To SET LOCK CODE
è
To operate (lock icon
Press Z
ERO
The first digit will be highlighted
è
To select the number
π †
To move to the next digit
Continue to follow these directions for all four numbers
Press the O
Press the M
When a viewer attempts to watch a blocked channel, this message appears:
The channel will remain blocked until the correct lock code is entered (see above for
information on setting your lock code).
Notes:
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.
40
button
ENU
appears)
to access the lock code
button to finish (your lock code is now set)
K
button when finished
ENU
THIS PROGRAM EXCEEDS
YOUR RATING LIMITS.
PLEASE ENTER LOCK CODE BY
10 KEY PAD TO UNLOCK
NO. - - - -