Advertisement
37. Remove 2 screws from the CPU
fan/heat sink, disconnect its cable
and remove it.
39. Remove 1 screw from the Bay
shield and remove it.
41. Remove 2 screw covers from the
front of the Display and the 2 screws
underneath.
43. Pry up the inverter with the
plastic screwdriver.
38. Turn the system board over,
remove 2 screws from the Expansion
Card Daughterboard cable and
remove it.
40. Stand the display on its top and
remove 2 screws from the bottom.
42. Pry around the perimeter of
cover to remove it. Be careful of
tape holding the cover to the LCD
along the top and bottom edges.
44. Disconnect the power cable
and backlight cable from the
inverter.
Advertisement
