Getting Started; Battery Information - Flex Br502 User Manual

GETTING STARTED

Battery Information

Your pager is powered by a single AAA-size alkaline battery. Do not use
any other battery type other than AAA alkaline.
When the battery is low, the pager will emit a low battery alert and the
battery icon will flash. While the pager does have a lithium power source to
protect data stored in memory, you should replace the battery immediately.
If the battery is not replaced the pager will shut down because the device
cannot support normal operation. Messages and settings will be lost if the
battery is not replaced immediately. However, protected messages will be
saved.
WARNING - Use of a battery other than an Energizer E92 OR a Duracell
MN2400, 1.5V AAA Alkaline Battery may affect the Intrinsic Safety UL rating
of the device.
4
Installing/Replacing the Battery
- Turn your pager off (see "Turning Your
Pager Off" on page 7)
- Holding the pager face down, press down
with your thumb and slide the battery door
in the direction of the arrow to open the
battery compartment (toward the outer
edge)
- Lift up the battery door to access the
battery. If neccessary remove the battery
door as shown on the right by removing
the battery door legs one after the other
- Remove the old battery and insert a new battery
so the polarity markings on the battery match the
polarity diagram on the housing. Replace the battery door
as shown by inserting the pair of battery door legs one after the other
- If the pager does not turn on, then check to make certain the battery has
been inserted correctly, or try another battery
5