Table of Contents
Advertisement
Setting Private Time
You can set your pager to Private Time. During this time the pager will still
receive messages as usual but it will not alert.
- From the Status screen, press the
"
" displays, and then press the
- The display shows "
(Function) button to select ON or OFF. Press the
button to confirm your selection
Note: If you select OFF the pager will return to the Status screen. If you
select ON proceed to the next step.
- To set pager START time scroll through hours by pressing the
(Function) button for each hour increment, then press the
Select) button to set and advance to the minutes. Repeat this step to set
minutes and "
" or "
", if you pager is set to display 12 hour time format
- Press the
(Read/ Select) button to set the END time by repeating
the above steps
- When complete, press the
18
Status screen
(Function) button 10 times until
(Read/ Select) button
" with a flashing "
" or "
" , toggle the
(Read/ Select)
(Read/
(Read/Escape) button to return to the
MESSAGES
The pager can store up to 18 personal messages. If you have programmed
your pager to alert you when it receives a message, an alert sounds (see
"Setting the Alert Type" on page 10).
Reading Messages
- From the Status screen press the
messages
- Continue pressing the
(Read/ Select) button to scroll through your
messages
- If your pager receives a message that contains errors, the character with
errors will blink
- Messages that are not "protected" will be lost when the pager's memory is
full. It is recommended that you delete unwanted messages frequently to
avoid message loss. (See page 20, Protecting/Unprotecting Messages.)
If at any time you wish to quit from the message screen there are two methods for escaping; 1) Press both
+
(Read/Select + Function) simultaneously, 2) Wait for 15 seconds. In both cases the display is
returned to the Status screen.
(Read/ Select) button to read you
19
Advertisement
Table of Contents
