Using The Monitor; Battery Performance - Nikon D810 User Manual

1 Measured at 23 °C/73.4 °F (±2 °C/3.6 °F) with an AF-S NIKKOR 24–120mm f/4G ED VR lens
under the following test conditions: lens cycled from infinity to minimum range and one
photograph taken at default settings once every 30 s; flash fired once every other shot. Live
view not used.
2 Measured at 20 °C/68 °F with an AF-S NIKKOR 70–200mm f/2.8G ED VR II lens under the
following test conditions: vibration reduction off, image quality set to JPEG normal, image size
set to Large, shutter speed
after shutter-release button has been pressed halfway for 3 s; six shots are then taken in
succession and monitor turned on for 5 s and then turned off; cycle repeated once standby
timer has expired.
3 Measured at 23 °C/73.4 °F (±3 °C/5.4 °F) with the camera at default settings and an AF-S
NIKKOR 24–120mm f/4G ED VR lens under conditions specified by the Camera and Imaging
Products Association (CIPA). Individual movies can be up to 20 minutes (1080/60p) in length or
4 GB in size; recording may end before these limits are reached if the camera temperature rises.
The following can reduce battery life:

• Using the monitor

• Keeping the shutter-release button pressed halfway
• Repeated autofocus operations
• Taking NEF (RAW) or TIFF (RGB) photographs
• Slow shutter speeds
• Using an optional UT-1 communication unit or WT-5 wireless
transmitter
• Using a GP-1 or GP-1A GPS unit
• Using a WR-R10/WR-1 wireless remote controller or ML-3
modulite remote control set
• Using VR (vibration reduction) mode with VR lenses
To ensure that you get the most from rechargeable Nikon
EN-EL15 batteries:
• Keep the battery contacts clean. Soiled contacts can reduce

battery performance.

• Use batteries immediately after charging. Batteries will lose
their charge if left unused.
/
1
s, focus cycled from infinity to minimum range three times
250
493