Travis Industries 99300677 Installation Instructions Manual

CHECK CONDITION OF SHIPMENT
Upon receipt of this kit, check the condition of the packaging. Damage to the package should be noted on the
carrier's freight receipt. Any damage claims as a result of shipping must be handled through the shipper. Travis
Industries will provide assistance in resolving shipping claims or replacing items not included in the package. Please
report any missing items immediately.
COMPATIBILITY
• Avalon Prairie*
• Lopi Berkshire*
• FPX 35 CB* (requires the optional receiver heat shield - 220-00020)
• 21 DV Fireplace (TV or RV)
* Requires installation of the optional blower
NOTE : This kit is designed as a stand-alone remote . If this remote is replacing a modulating remote, you will need the retrofit
kit (99300 647 or 99300649 depending on model).
ITEMS NEEDED FOR ASSEMBLY
• Three AAA Batteries
PACKING LIST
• Remote Receiver
FCC EQUIPMENT REQUIREMENTS
WARNING : Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
N O T E : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiver.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
INSTALLATION WARNINGS
! Place the remote receiver in the location detailed in these instructions. Placing the receiver in other locations may
cause the receiver to become too hot and degrade and will void the warranty.
! All 110 AC wiring must be done by a qualified electrician and shall be in compliance with local codes and the
National Electric Code ANSW/NFPA no. 70 (in the United States).
! This kit must be installed by a qualified technician.
! Do not connect 110 VAC to the gas control valve, on/off switch, or thermostat posts.
! The remote control is carefully engineered and MUST be installed only as specified. It is tested safe when
installed in accordance with this installation manual If you modify it or any of its components, you may possibly
cause a fire hazard. It is your responsibility to read all instructions before starting installation and to follow these
instructions carefully during installation.
! Disconnect the power (turn off the household breaker) and shut off the gas supply to the heater before installing
the remote control.
Page 1 of 6
Remote Thermostat Installation Instructions
(See list below for compatible models - 99300677)
• Avalon Salish • Avalon Cedar*
• Lopi Heritage • Lopi Allegiance*
• 864TRV*
• Remote Control
• Avalon Hideaway (TV or RV)
• Lopi Sturbridge*
• DVL Fireplace EF
• Receiver Mounting Bracket
9/28/05
• Tree of Life*
• Lopi Sweet Dreams*
Travis Industries, Inc.
• Spirit DV EF