1
1. Hex wrench 5
2. Motor housing cover
2
1. Brush holder cap
2. Screwdriver
1
2
1. Screwdriver
2. Plate 50
1
1. Hammer grease
Use a hex wrench to remove the motor housing cover.
002959
2
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
002960
brushes, insert the new ones and secure the brush holder caps.
1
Lubrication
002974
This tool requires no hourly or daily lubrication because it has a grease-
packed lubrication system. It should be relubricated after every 6 months of
operation. Send the complete tool to Makita Authorized or Factory Service
Center for this lubrication service. However, if circumstances require that you
should lubricate it by yourself, proceed as follows.
First, switch off and unplug the tool.
Remove the plate 50 using a screwdriver, then replenish with fresh grease
002975
(60 g). Use only Makita genuine hammer grease (optional accessory). Filling
with more than the specified amount of grease (approx. 60 g) can cause faulty
hammering action or tool failure. Fill only with the specified amount of grease.
Reinstall the plate 50 and secure with the screws.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
7