Motorola Spectra Installation Manual page 3

Installation Requirements for Compliance with
Radio Frequency (RF) Energy Exposure Safety
This radio is intended for use in occupational/controlled conditions, where users have full knowledge of their
exposure and can exercise control over their exposure to meet FCC limits. This radio device is NOT authorized
for general population, consumer, or any other use.
To ensure compliance to RF Energy Safety Standards:
• Install only Motorola approved antennas and accessories.
• Be sure that antenna installation is per Antenna Installation on page 3-8 of this manual.
• Be sure that Product Safety and RF Safety Booklet enclosed with this radio is available to the end user
upon completion of the installation of this radio.
Before using this product, the operator must be familiar with the RF energy awareness information and
operating instructions in the Product Safety and RF Exposure booklet enclosed with each radio (Motorola
publication part number 6881095C99_) to ensure compliance with Radio Frequency (RF) energy exposure
limits.
For radios installed in vehicles fuelled by liquefied petroleum gas, refer to the (U.S.)
National Fire Protection Association standard, NFPA58, for storage, handling, and/or
! !
container information.
W A R N I N G
This radio has a transmitter Time-out Timer that disables the transmitter during a transmission after a predefined
time period, which by default is set to 60 seconds.
It is recommended NOT to change the default 60 seconds time period for the Time-out Timer
as the radio is intended for intermittent duty cycle operation.
!
C a u t i o n
For a list of Motorola-approved antennas and other accessories, visit the following web site, which lists approved
accessories for your radio model:
http://www.motorola.com/governmentandenterprise
Standards
ATTENTION!