Operating Instructions; Configuration; Lamp Head Connection - Profoto D4 1200 Air User Manual

Operating instructions

Configuration

Before connecting any heads, the D4 Air generator has to be configured to be compatible
with the lamp heads to be used; Acute/D4 series or Pro series of heads.
Check configuration
While in standby mode, simultaneously press the Slave Button [6] and the Set Button [7]
to display the configuration in the Auxiliary Functions Display [8]:
• For connection of Pro series heads, check that "Pro" is displayed (default setting).
• For connection of Acute/D4 series heads, check that "Acu" is displayed.
Change configuration
1. If connected, disconnect the power cable from the Mains Socket [1].
2. Disconnect any connected heads, as a precaution not to risk any damage.
3. Simultaneously press and hold down the following three buttons: the Ws/f-stop Button
[11] and the Head/Model Button B and C [12].
4. While still pressing the three buttons, connect the power cable to the Mains Socket [1]
and to AC mains supply.
5. While still pressing the three buttons, wait until first the current configuration is
displayed in the Auxiliary Functions Display [8] and then the new configuration.
6. Three beeps will confirm the new configuration setting, which will be displayed as long
as the three buttons are being pressed.
7. Release the three buttons.

Lamp head connection

With Profoto's special lamp head connection, heads can be connected and disconnected
safely even if the D4 Air generator is turned on.
Ensure that the configuration setting of the generator is correct. See instructions in section
Configuration above.
Connect the lamp heads to the Lamp Head Sockets [9]. Always start with socket A, then B, etc.
When connecting the lamp head plug, align the white dot on the plug with the white dot on
the generator panel. Secure by turning the ring on the plug clockwise.
www.profoto.com
17