Set Lock Code; Auto Demo - JVC I' Art Pro AV-32DF74 User Manual

Initial Setup

Set Lock Code

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes pre-
set with a lock code of "0000". You may change the code to any four-digit number you wish. To
change the lock code, follow the steps below.
Press the M
To SET LOCK CODE
π †
è
To operate (lock icon
Press Z
ERO
The first digit will be highlighted
è
To select the number
To move to the next digit
π †
Continue to follow these directions for all four numbers
Press the OK button to finish (your lock code is now set)
Press the Menu button when finished
When a viewer attempts to watch a blocked channel,
this message appears:
The channel will remain blocked until the correct lock
code is entered (see above for information on setting
your lock code).
Notes:
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.

Auto Demo

This function lets you preview the many different viewing modes of your TV. It will cycle through
"Multi Screen Demo", "Picture in Picture Demo", all of the different "Aspect" ratios and all of the
different "Video Status" modes.
Press the M
To AUTO DEMO
π †
è
To turn AUTO DEMO ON or OFF
Note:
• To stop auto demo, press the M
demo by pressing the π † buttons, and turn it off by pressing
è
the buttons. Press the M
36
button
ENU
appears)
to access the lock code
button
ENU
button, and select auto
ENU
button to finish.
ENU
�������������
���������
��������������������
��
������ �������
������������������������
�������������������
�������������������������
������������������������
���������������������������
�������������
��������
����������������
���������������
������
�������������
���������
���������
������ �������
����
����
����
���
����
����