Set Lock Code - JVC AV 32D104 User Manual

Initial Setup

Set Lock Code

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes pre-
set with a lock code of "0000". You may change the code to any four-digit number you wish. To
change the lock code, follow the steps below.
Press the M
To SET LOCK CODE
π †
è
To operate (lock icon
Press Z
ERO
The first digit will be highlighted
è
To select the number
To move to the next digit
π †
Continue to follow these directions for all four numbers
To FINISH
π †
è
To save settings and exit
(your lock code is now set)
Press the E
When a viewer attempts to watch a blocked channel, this message appears:
The channel will remain blocked until the correct lock code is entered (see above for
information on setting your lock code).
Notes:
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.
32
button
ENU
appears)
to access the lock code
button when finished
XIT
THIS PROGRAMMING EXCEEDS
YOUR RATING LIMITS.
PLEASE ENTER LOCK CODE BY
10 KEY PAD TO UNLOCK IT.
NO. - - - -