Bluetooth Communication - Extech Instruments EX845 User Manual

Bluetooth Communication

The meter includes a Bluetooth module designed to communicate with the Flir T/B360,
T/B400 or i/b60 cameras The combination of a clamp meter and an IR camera is used for
analysis and documentation of temperature and current readings on single and three
phase power distribution panels.
Setup
1. Enable the EX485 bluetooth by pressing and holding the side Bluetooth/Backlight
button for two seconds. On the second beep the bluetooth icon will appear in the
display.
2. Pair the meter to the camera by following the "Pairing Bluetooth devices" section in
the camera manual.
3. Once paired, the data from the EX485 will be continuously displayed and updated on
the camera display.
EX845
Notes:
1. More than one meter can be paired with one camera to observe multiple legs in three
phase systems.
2. If a paired bluetooth device is removed from a camera list, perform a camera restore.
3. During initialization it can take up to 15 seconds to establish communication and
display results.
4. The data transmit function works in IR, Picture in Picture and Fusion modes, it does
not work in Digital camera mode.
5. If data stops appearing in the display, check that the bluetooth icon is active on the
meter's display.
Image Editing
A single or series of readings can be applied to a single image by saving and entering the
image edit mode.
EX845 EX845 EX845
2 3
10 EX845-EN V2.1 02/10