Table of Contents
Advertisement
Steps to enable Direct Link Setup function:
1. Click the "Direct Link Setup Enable" checkbox.
2. Change to "Network" function. Add an AP that supports DLS features to the Profile.
3. Fill in the blanks of Direct Link with MAC Address of STA. The STA must conform to these two
conditions:
Connect with an AP that supports DLS features.
y
Ensure that DLS is enabled
y
4. Fill in the Timeout Value and then click
5. After configuring the DLS successfully, the MAC address and Timeout Value are displayed in
the "DLS Status".
6. If you want to disconnect Direct Link Setup, select the list in "DLS Status" and then click on the
Version: 2.0
button.
.
DLS Status
23
Advertisement
Table of Contents
