Filling Boiler With Water - Monster CLASSIC FLOOR STEAMER (EZ1) User Manual

D. Filling Boiler with Water
WARNINGS:
Carefully read all instructions before removing Boiler Cap.
•
Always unplug appliance before filling the Boiler.
•
*IMPORTANT*
Use ordinary tap water. Distilled or demineralized water is
recommended if tap water is too hard. DO NOT add detergents,
perfumes, oils, or other chemical substances to the Boiler. The
product warranty will be null and void if anything other than water
is added to the Boiler.
Follow these instructions to avoid overfilling
the Boiler.
• Be sure appliance is unplugged from the
electrical power outlet, and has cooled for
at least 5 minutes before filling with water.
• Make sure Handle Assembly is in the
upright "off" position. Remove Boiler Cap
by turning it counterclockwise.
200 ml
100 ml
• Replace Boiler Cap by turning it clockwise.
Do not tighten Boiler Cap too much – finger
tightening is sufficient to lock the steam in the Boiler.
If using cold water, heating time is about 3-5 minutes. If using warm
water, heating time is reduced.
*IMPORTANT*
• Do not overfill the Boiler as excess water will be flushed out of the Boiler
before dry steam will emit.
• If re-filling the Boiler while Steamer has been in use, be sure to allow
Steamer to cool for at least 5 minutes and loosen Boiler Cap slowly to
allow any excess steam to escape before completely removing Cap.
(See page 10, "Refilling Boiler During Use" for detailed instructions.)
8
Before Use
• Pour in 600 mls of water using
the Measuring Cup and Filler
Funnel provided – fill cup to the
"200 ml" marking three times.
Be careful not to overfill the
Boiler.
Please note that excess
water will be flushed out during
use if the Boiler is overfilled,
resulting in wet floors.