Advertisement
5-1 a.b Tilt up the rear of the hard drive case and pull it gently by its edges only, because static electricity
can permanently damage the computer parts. Please use the given HDD shielding tray (refer to Figure 5-
1a)
5-2 a.b.c.d Unscrew all 4 Phillips screws that are on the side of the HDD.
5-3 a.b.c.d Remove the HDD connector (if replacing the older hard drive) by pulling it away from the hard
drive. Insert the HDD connector to HDD. Make sure to align the connector and the hard drive pin.
Improper alignment will cause damage to the hard drive and notebook.
Advertisement
