Advertisement
2-3 Use a flathead screwdriver to disengage (Open) the socket actuator, as shown in figure 2-3a below.
The socket actuator should open after only a half turn, and then you should be able to remove the
processor with your fingers.
2-4 Place new processor into the socket. Align processor's pin A1 (shown in figure 2-4) with the arrow on
the micro-FCPGA socket. Pin A1 of the processor is identified with an embroidered corner and pin A1 of
the socket is identified with a small arrow. If the processor does not drop completely into the socket, turn
the actuator until the processor drops in completely.
!!!You do not have to press down the processor. If the processor does not drop completely into
the socket, turn the actuator until the processor drops in completely.
2-5 While gently holding the processor down with your finger, secure the processor in the socket by
closing the socket actuator with a screwdriver (See Figure 2-5)
Advertisement
