Functional Description - Makita HR2450 Instruction Manual

FUNCTIONAL
DESCRIPTION
1
1. Switch trigger
2. Lock button
1
1. Lamp
A
B
2
1. Switch trigger
2. Reversing switch lever
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Switch action
001292
CAUTION:
• Before plugging in the tool, always check to see that the switch trigger
2
actuates properly and returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed is increased by
increasing pressure on the switch trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then push in the lock but-
ton. To stop the tool from the locked position, pull the switch trigger fully, then
release it.
Lighting up the lamps
For model HR2450F/HR2450FT
003572
CAUTION:
• Do not look in the light or see the source of light directly.
To turn on the lamp, pull the trigger. Release the trigger to turn it off.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to
scratch the lens of lamp, or it may lower the illumination.
Reversing switch action
001293
For Model HR2450,HR2450F,HR2450X,HR2450T and HR2450FT
This tool has a reversing switch to change the direction of rotation. Move the
reversing switch lever to the
position (B side) for counterclockwise rotation.
1
CAUTION:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the tool comes to a complete stop.
Changing the direction of rotation before the tool stops may damage the
tool.
• When you operate the tool in counterclockwise rotation, the switch
trigger is pulled only halfway and the tool runs at half speed. For
counterclockwise rotation, you cannot push in the lock button.
position (A side) for clockwise rotation or the
5