OPERATING INSTRUCTIONS
1. Enter the walk in tub, close the door and secure the safety chrome lever in the down position to
ensure the closure of the door. The door can locked with the handle from a seated or standing
position. Do not apply any body weight on the door when entering and exiting the tub. The
door and the door hinges are well built and are very durable. However, leaning on or applying
users weight on the door may damage the door by changing the alignment of the door and
creating water leaks. Such damages are not covered by the warranty. It is recommended to
leave the door in the open position when the tub is not used to extend the life of the seal.
2. To fill up the bath tub with water, adjust desired temperature of the water.
3. Fill walk in tub as desired or 2" inches below the over flow holes inside the walk in tubs.
4. To exit the walk in tub simply open the dual drain over flow switches and your tub shall drain in
80 sec or less.
5. Once the walk in tub is completely empty you are safe to exit the walk in tub.
6. There are no user serviceable parts located under the tub (behind the removable access panels).
7. Usually, a mild detergent will remove construction debris. More stubborn debris may be
removed with denatured alcohol, or Clorox Soft Scrub cleaner. Light scratches and dulled areas
may be restored to original luster by rubbing with a fine grade automotive type cleaning and
polishing compound.
CLEANING AND MAINTENANCE
It is recommended that once a month, unscrew (counter clock wise) the suction cover and clean
away any hair, lint or debris from the cover and housing ‐ Then remount the cover in place.
Never operate the unit with the safety suction cover off. Do not use abrasive cleaners, as they
will scratch and dull the surface of the acrylic. Plaster can be removed using a wooden edge.
DO NOT USE METAL SCRAPER, WIRE BRUSHES, OR WATER
*To clean your bathtub, use a mild nonabrasive liquid detergent solution.
14