PowerBass PS-WB110 Application Manual
  1. Manuals
  2. Brands
  3. PowerBass Manuals
  4. Subwoofer
  5. PS-WB110
  6. Application manual

PowerBass PS-WB110 Application Manual

Single subwoofer bass reflex system
Hide thumbs Also See for PS-WB110:

Advertisement

Table of Contents

PS-WB110
PS-WB112
Single Subwoofer Bass Reflex System
Application Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PS-WB110 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for PowerBass PS-WB110

Summary of Contents for PowerBass PS-WB110

  • Page 1 PS-WB110 PS-WB112 Single Subwoofer Bass Reflex System Application Guide...
  • Page 2 ∆ Warning ∆ Continuous exposure to sound pressure levels in excess of 100 dB can cause permanent hearing loss. PowerBass Autosound Speakers are capable of producing sound pressure levels well over 170 dB. Please observe all local sound ordinances while listening to your PowerBass Autosound system.
  • Page 3 POWERBASS AUTOSOUND LOADED ENCLOSURE FEATURES Heavy-duty Box Design: The enclosure is constructed from non-resonant 5/8” panels that have been glued, braced and sealed. Each box is finished in a stylish two tone RFG aviation grade vinyl covering. Bass Reflex Single Port System: Utilizing a Bass Reflex design offers increased efficiency at low frequencies.
  • Page 4 275W/550W UNPACKING THE ENCLOSURE Every attempt has been made to transport your new PowerBass Bass Reflex subwoofer system safely. Carefully unpack the enclosure and inspect it thoroughly for any damage that may have occurred dur- ing shipping. Notify your local PowerBass dealer immediately should you notice any damage prior to installing the unit.
  • Page 5 • Use speaker wire large enough to carry the full power of your amplifier. 14-gauge or larger should be adequate. (Speaker wire not included) Your PowerBass Bass Reflex subwoofer system needs to be installed some place where it can oper- ate efficiently and not endanger the occupants of the vehicle.

  • Page 6: Wiring And Connections

    WIRING AND CONNECTIONS The PowerBass Bass Reflex subwoofer system consists of a single 4-ohm voice coil woofer. Check to see that your amplifier is optimized to drive this load. A single spring loaded push terminal cup provides a quick and easy connection from your bass ampli- fier to your Bass Reflex system Fig.1...

  • Page 7: Sound Check

    SOUND CHECK Your PowerBass Bass Reflex Subwoofer system will operate at optimum performance after a break- in period. Allow the system to play 20 to 30 hours at moderate levels. To sufficiently drive either the Single Woofer 10 or 12-inch system, we recommend using an amplifier with at least 100 watts RMS mono output.

  • Page 8: Warranty Notes

    PowerBass Importer/Distributor in your country. This manual is the exclusive property of PowerBass USA, Inc. Any reproduction of this manual, or use other than its intentions is strictly prohibited without the express consent of PowerBass USA, Inc.
  • Page 9 This warranty applies only to PowerBass products sold to consumers by Authorized PowerBass Deal- ers in the United States of America. Products purchased by consumers from a PowerBass dealer in another country are covered only by that country’s Distributor and not by PowerBass USA.
  • Page 10 PowerBass Autosound – A division of PowerBass USA, Inc. 13936 Mountain Avenue – Chino, CA 91710 Tel. (909) 993-5399 – Fax (909) 993-5393 www.powerbassusa.com...

This manual is also suitable for:

Ps-wb112

Table of Contents