Initial Configuration And Deployment; Remote System Installation - Compaq Deskpro EN Series Maintenance & Service Manual

2.8

Initial Configuration and Deployment

Compaq computers come with a preinstalled set of system software. Automated System
Installation and Remote System Installation enable you to replace the preinstalled software with a
customized set of system and application software for consistent, standard software deployment.
The Compaq Restore CD, ROM-based setup, and ACPI-ready hardware provide further assistance
with selective recovery of system software, configuration management and troubleshooting, and
power management.
2.8.1

Remote System Installation

Remote System Installation allows you to start and set up your system using the software and
configuration information located on a network server. The Remote System Installation feature is
usually used as a system setup and configuration tool, and can be used for the following tasks:
„
Installing the optional Setup partition. The partition should be installed only if you wish to
use the previous generation of Compaq Computer Setup and Diagnostics utilities.
„
Formatting a hard drive.
„
Installing an operating system.
„
Installing application software or drivers.
To initiate Remote System Installation, press F12 when the F12=Network Service Boot message
appears in the lower-right corner of the Compaq logo screen. Follow the instructions on the screen
to continue the process.
2-14 Software Reference