Compaq Deskpro EN Series Maintenance & Service Manual page 107

5.10.2 5.25-Inch Drive Release Latch Removal
1. Prepare the computer for disassembly (Section 5.4).
CAUTION: When the computer is plugged into an AC power source, there is always voltage applied to the
system board. You must disconnect the power cord from the power source before opening the computer
to prevent system board or component damage.
2. Remove the system unit cover (Section 5.6).
3. Disconnect the power and date cables from the rear of the drives.
4. Remove all drives from the 5.25-inch drive bays (Section 5.9.2).
5. Rotate the drive cage to its full upright position.
6. From inside the drive bay, push out on the retainer tabs that hold the green drive release latch in
position, then slide the drive release latch up towards the rear of the drive bay to release it.
Removing the 5.25-Inch Drive Release Latch
To install the drive release latch, reverse the removal procedures.
Refer to Section 5.8 for proper power cable connections.
CAUTION: When returning the drive cage to its normal position, use caution to prevent damaging the
data and power cables.
Compaq Deskpro EN Series of Personal Computers 5-17