Drive Release Latches; 3.5-Inch Drive Release Latch Removal - Compaq Deskpro EN Series Maintenance & Service Manual

5.10

Drive Release Latches

5.10.1

3.5-Inch Drive Release Latch Removal

1. Prepare the computer for disassembly (Section 5.4).
CAUTION: When the computer is plugged into an AC power source, there is always voltage applied to the
system board. You must disconnect the power cord from the power source before opening the computer
to prevent system board or component damage.
2. Remove the system unit cover (Section 5.6).
3. Disconnect the drive and power cables from the rear of the computer.
4. Remove the side-mounted hard drive (Section 5.9.1).
5. From inside the drive bay, push out on the retainer tab that holds the green drive release latch in
position, then slide the latch up towards the rear of the drive bay to release it.
Removing the Drive Release Latch from the Side-Mounted Drive
To install the drive release latch, reverse the removal procedures.
Refer to Section 5.8 for proper power cable connections.
CAUTION: When installing the hard drive, do not damage the seal tape as this may void the warranty.
CAUTION: When returning the drive cage to its normal position, use caution to prevent damaging the
data and power cables.
5-16 Desktop Removal and Replacement