E.F. Johnson Company 5100 ES Operating Manual page 165

Miscellaneous
Invld Ch - The channel entered by the user in keypad programming is not valid.
Key Fail - The encryption key required by the current selected group/channel is not
valid.
Kypd Lockd - The keypad lock function is active and key presses are not accepted in
this mode.
Kset Fail - The encryption key set chosen by the user is not valid.
List Only - Direct entry of a unit ID or phone number is disabled.
Locked - A selector lock command has been received and zone and channel changes
are not accepted.
Lost Signl - Signal from the infrastructure has been lost during an interconnect call.
Msg Failed - The message sent to the system was not acknowledged (applies to
conventional messaging.
Narrow - The current conventional channel is programmed as a narrow channel.
No Ack - The radio did not receive an Acknowledgement for the current signaling
attempt.
No Edit - The current list is not able to be edited.
No Encrypt - Encryption is not available for the selected channel.
No Items- The menu the user attempted to access contains no items.
No List - No list is available for the selected channel.
No Message - No message is programmed for transmission.
No Reply - Radio cloning failed due to no response.
No Sat Rec- The user attempted to enter GPS mode but the receiver does not have a
satellite lock.
No Service - OTAR service is not available.
No Site - No site with a verified ID is yet on the dynamic site list.
No Keys - No keys are available for the key select function.
Out Of Rng - This error indicates no control channel has been found for trunking
operation.
Parms Fail - The checksum of the profile / user parameters does not match the
calculated checksum. This indicates that there is an error in the parameters file. This
message only occurs if the redundant copy of the parameters is also corrupt or is unable
to be used.
Reg Failed - The radio was unable to complete registration on the system.
Rekey Fail - This error indicates a failure in a rekeying process.
Rx Only - The selected channel is Rx only.
ES Series Models II/III Portable Radio Operating Manual 8-3