Advertisement
3
SED 900 Commissioning
Testing unit
1/ Ensure the following leds are on
• Pwr
• Rf ok
2/ Ensure IN or Out are selected
3/ When a card is presented to reader the
following should occur;
card
Tx and Rx leds will flicker and the reader
HID
will beep
Access or Denial is just like a wired reader
NOTE: if you are in a poor signal area or
you loose signal during a badged card
the following could occur
The wireless reader will wait for 5 seconds
for a response from the master controller. if
the signal or card transmission is corrupted,
the reader will sound continually for 5 seconds.
So present card again
Advertisement
