D-Link dsl-504T User Manual page 35

1. Choose the Bridge Mode option from the WAN Settings pull-down menu.
2. Under the ATM VC Settings at the top of the window should not be changed unless you have been
instructed to change them. However, if you are instructed to change the VPI or VCI values, type in the
values assigned for your account. Leave the PVC and Virtual Circuit setting at the default (Pvc0 and
Enabled) values for now. This can be used later if you are configuring multiple virtual circuits for your ADSL
service. For more information on ATM VC Settings, see the table on the page below.
3. Under the Bridge Mode heading, choose the Connection Type from the pull-down menu. This defines
both the connection type and encapsulation method used for your ADSL service. The available options are
1483 Bridged IP LLC and 1483 Bridged IP VC-Mux. If have not been provided specific information for the
Connection Type setting, leave the default setting.
4. Most users will not need to change ATM settings. If this is the first time you are setting up the ADSL
connection it is recommended that you leave the Service Category settings at the default values until you
have established the connection. See the table on the below page for a description of the parameters
available for ATM traffic shaping.
5. When you are satisfied that all the WAN settings are configured correctly, click on the Apply button.
6. The new settings must be saved and the Router must be restarted for the settings to go into effect. To save
and reboot the Router, click on the Tools directory tab and then click the System button. In the System
Settings window, click the Save and Reboot button under Save Settings and Reboot the System.
7. Click OK when the following "Save and restart?" dialog box opens.
8. The Router will save the new settings and restart. Upon restarting the Router will automatically establish
the WAN connection.
ATM Settings - Traffic Shaping
The ATM settings in the WAN Settings windows for the different connection types can be used to adjust QoS
parameters for ADSL clients. This may not be available to all ADSL accounts.
Page 35 of 96
DSL-504T Generation II ADSL2+ Modem Router
ATM Settings for WAN connection
www.dlink.com.au