Hard Disk Connector: Ide1 - Medion MS-7091 User Manual

Smart Card Reader Connector: JSMC1
The mainboard provides one smart card reader header for users to connect
to smart card interface.
JSMC1

Hard Disk Connector: IDE1

The mainboard has one 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100
controller that provides PIO mode 0~4, Bus Master, and Ultra DMA33/66/100 function.
You can connect up to 2 hard disk drives, CD-ROM, 120MB Floppy (reserved for
future BIOS) and other devices. The connector supports the provided IDE hard disk
cable.
IDE1 (Primary IDE Connector)
The first hard drive should always be connected to IDE1. IDE1 can connect a Master
and a Slave drive. You must configure second hard drive to Slave mode by setting the
jumper accordingly.
MSI Reminds You...
If you install two hard disks on cable, you must configure the second
drive to Slave mode by setting its jumper. Refer to the hard disk docu-
mentation supplied by hard disk vendors for jumper setting instructions.
Pin
8
2
1
3
5
7
1
7
Hardware Setup
Pin Definition
Signal Pin Signal
VCC5 2 SCRST#
SCPWR# 4 SCPSNT
GND 6 SCIO
SCLED 8 SCCLK
IDE1
2-15