JVC 0110SKH-MW-MT Instructions Manual page 15

Operation guide
Shows the buttons for each
operation.
• The menu automatically disappears in about 30 seconds after the previous operation.
• Some items may not appear on the menu depending on the input or the input signal.
• The items controlled by the MAKE system do not appear on the menu.
NOTE
Example of the vector scope
Ex.: When the color bar is displayed
Example of the wave form monitor
Ex.: When the luminance signal is Y, "MARKING" is set to "ON"
and "LEVEL" is set to "080"
Red White
Y
Video signal
Start
• The wave which goes over the value set on "LEVEL" is
indicated in red.
• The display differs depending on the input signal or the
setting of "WAVE DISPLAY."
SCOPE SETTING* 1
Settings for the wave form monitor and vector scope
Item To do
GAIN Adjust the gain level for the incoming wave form data.
SIZE* 2 Select the size of the wave form monitor and vector scope window.
POSITION* 2 Select the position of the wave form monitor and vector scope
window.
TRANSPARENT Activates/deactivates the function to make the window translucent.
AUTO OFF Activates/deactivates the function to make the wave form monitor and
vector scope window go off automatically 15 minutes after displaying it.
WAVE DISPLAY Select the wave form for the wave form monitor.
WAVE FILTER Activates/deactivates the low-pass filter for the incoming wave form
data.
WAVE OVER Adjust the over level for the incoming luminance (Y) and RGB
LEVEL signals.
MARKING Activates/deactivates the function to change the color of a wave form
when the signal exceeds the limit specified on "LEVEL" (☞ below).
LEVEL Adjust the lower limit for the over level.
* 1 Wave form monitor does not work for DVI signals (PC input).
Vector scope does not work for RGB signals.
* When you set "SIZE" to "LARGE," the window is displayed in the center of the screen regardress of the "POSITION"
2
setting.
SYNC FUNCTION
Settings for the synchronization with signals
Item
NO SYNC ACTION Select the screen status when no signal is coming in.
DELAY TIME
SYNC INPUT
SEL.* 3
LOW LATENCY
End
• When setting "NO SYNC ACTION" to "GRAY B.," the screen color changes to gray and the power consumption
of the back light is saved by half. Selecting "P.SAVE" (power save mode) saves more power consumption by
turning off the back light.
* 3 Memorized for each input.
To do
Select the period until the screen status changes as selected
in "NO SYNC ACTION" after signals stop coming in.
Select the sync signal for the VIDEO1, VIDEO2 and
COMPO./RGB input.
Activates/deactivates the function to shorten the time
taken to display the picture (low latency function).
• If the picture is not displayed steadily while "ON" is
selected, select "OFF."
• While "ON" is selected, the displayed picture may
become unstable when an operation using buttons on
the front panel or the menu is performed, or when the
signal format changes.
Setting value
–10 – +10
NORMAL, LARGE
1 (lower right), 2
(lower left), 3 (upper
left), 4 (upper right)
ON (translucent),
OFF (normal)
ON, OFF
Y/Pb/Pr (HD signals)
Y/Cb/Cr (SD signals)
R/G/B (RGB signals)
FLAT (no filter),
LOWPASS
☞ "NOTE"
OFF, ON
070 – 109
Setting value
OFF, P.SAVE (power save
mode), GRAY B. (gray screen)
30sec., 5min., 15min.
INT. (Internal sync),
EXT. (External sync)
ON, OFF
15
ENGLISH