Models Rm6270, Rm6271, Rm6361 - Swift Motorhomes Owner's Handbook Manual

Equipment Details
The flame failure device will automatically
shut off the gas to the burner if the flame is
blown out. On electric ignition versions, the
flame failure device will also shut off the gas
if the burner does not re-light within about a
minute of the flame being blown out.
MODELS RM6270, RM6271,
RM6361, RM6401, and RM6291
Cleaning
Before using the refrigerator, it is advisable to
clean the appliance both inside and out.
Use a soft cloth and lukewarm water with a
mild detergent.
Then rinse the appliance with clean water
and dry thoroughly.
Remove dust from the refrigerator unit at
yearly intervals using a brush or soft cloth.
To avoid deterioration of materials:
Do not use soap or hard, abrasive or soda-
based cleaning agents.
Do not allow the door seal to come into
contact with oil or grease.
USING THE REFRIGERATOR
The refrigerator is silent in operation.
When the appliance is first put into operation,
there may be a mild odour, which will
disappear after a few hours. Ensure the living
area is well ventilated.
48
The freezer compartment should be cold
about one hour after switching on the
refrigerator.
The refrigerator will take several hours to
reach its operating temperature.
Control
A. Manual Ignition (e.g. RM6270)
A = energy selector switch
B = gas/electric thermostat
C = manual ignition button ('Piezo
ignition')
B. Automatic Ignition (e.g. RM6271, RM6361,
RM6401 and RM6291)
A = energy selector switch
B = gas/electric thermostat
C = 'automatic ignition' indicator
Note: The refrigerator is equipped to operate
off mains power, 12V DC or liquid gas. The
desired power option is selected by means of
energy selector switch (A). Energy selector
switch (A) has four settings: AC mains power,
DC (12V), gas (liquid gas), O (off).
Electrical Operation
12V DC Operation
-
+
Energy Selector Switch
Your refrigerator will only operate on 12V
when the engine of the vehicle is running.
1. Set the energy selector switch (A) to
The refrigerator will run continuously without
thermostatic control.
WARNING:
When in transit, your refrigerator should be
run on 12V and NOT on gas.
Mains power (230V)
Note: This option should only be selected
where the supply voltage of the
connection for power supply corresponds
to the value specified on the data plate.
Any difference in values may result in
damage to the appliance.
Off
AC
12V
Gas