Table of Contents
Advertisement
Anti-Shock Protection
This function minimizes sound interruption caused by vibrations, by utilizing audio data that has been stored in the memory ahead
of the following time:
For Audio CD: Up to 45 seconds worth (Anti-Shock Protection on/off selectable)
For MP3:
Up to 120 seconds worth at 128 kbps (Anti-Shock Protection is fixed to on.)
Normally, the "A.S.P." indicator lights up on the display and the Anti-Shock Protection is in effect.
A.S.P indicator
When the disc is played, as the audio data gradually stored in the memory, the "A.S.P." indicator changes from blinking to lighting:
[Fully stored]
To cancel the Anti-Shock Protection (Audio CD only)
Press the A.S.P./T.SEARCH button in stop mode or during playback.
The "A.S.P." indicator goes out on the display.
To activate the Anti-Shock Protection again (Audio CD only)
To activate the Anti-Shock Protection again, press the A.S.P./T.SEARCH button once more.
Notes:
• The Anti-Shock Protection can be enabled or disabled during play, and this may cause a slight interruption in the sound because
the disc's rotational speed changes.
• Turning off the Anti-Shock Protection will save battery life more or less.
Preventing Accidental Operation (Hold)
HOLD
OFF
ON
The HOLD switch is prepared to prevent an accidental operation
by an unexpected button press.
Setting the HOLD switch ON prevents the fol-
lowing:
• Powering on the unit accidentally (which can cause the batter-
ies to go dead).
• Play being cut off unexpectedly.
To set the unit in hold mode
• Set the HOLD switch to the ON position.
5
"HOLD " indication
When the unit is in hold mode, "HOLD" will be displayed if a
button is pressed.
To release the function
Set the HOLD switch to OFF position.
Note:
Before turning on the unit, be sure that HOLD is OFF.
Otherwise, you cannot turn on the unit.
Using the unit with an
audio system
Using a stereo connection cable (not included), you can listen to
CDs through your audio system.
• Connect the cable to the amplifier after turning off its power.
• Do not connect the cable to the PHONO jacks on the amplifier.
• Obtain the optional connecting cable if the amplifier comes
with mini-phone jacks.
• Adjust the volume level on the amplifier.
Notes:
• To obtain original sound, set HBS to "OFF".
Maintenance
Maintaining the unit
Wipe the unit with a soft cloth. Remove stubborn dirt using a
cloth which has been dipped in water or soapy water and wrung
out, and then wipe dry.
• If you intend to use a chemically treated cleaning cloth, read
its directions first.
• Do not use alcohol or paint thinners.
Maintaining the lens
Open the lid and clean the lens as shown in the figure.
Use a cotton swab to gently wipe off any finger-prints.
Recommended product: Lens cleaner kit
Lens
Air blower for
camera lens
Lens
Advertisement
Table of Contents
