Electrical & Gas Supply Requirements - Haier GDE480BW User Manual

ALCOVE OR CLOSET REQUIREMENTS
MINIMUM CLEARANCES
• This dryer can be installed with 0" (0 cm) minimum clearance on the right and
left sides, as well as the back. A 1" (2.5 cm) minimum clearance is required for the
front.
OTHER REQUIREMENTS
• This dryer must be vented to the outdoors.
• Do not install the dryer in a closet with a solid door.
• A closet door must be louvered or vented with a minimum of 120 sq. in.
(774.2 sq. cm) of opening equally divided at the top and bottom of the door. The
airfl ow must not be obstructed in any way.
• No other fuel-burning appliance shall be installed in the same closet as the gas
dryer.
ELECTRICAL & GAS SUPPLY REQUIREMENTS
ELECTRIC DRYER (U.S. ONLY)
The dryer must be connected to a properly grounded 3 or 4-wire, single
phase, 120/240 volt (or 120/208 volt), 60Hz, AC-only electrical supply
on a separate 30- amp circuit, fused with 30-amp time-delay fuses or
circuit breakers. Use separately fused circuits for washers and dryers,
and do not operate a washer and dryer on the same circuit.
This appliance must be grounded. In the event of an electrical short
circuit, grounding reduces the risk of electric shock by providing an
escape route for the electrical current.
8
0"
(0 cm)
2
60 in.
2
(387.1 cm )
60 in. 2
2
(387.1 cm )
WARNING
WARNING
1"
15"
(2.5 cm)
(38.1 cm)