Procedure For Connecting Inverter To Remote Dc Source; Operating Time; Powering An Ac Load - Vector Power City VEC029ACY Owner's Manual

4.3.1 PROCEDURE FOR CONNECTING INVERTER TO REMOTE DC SOURCE

Open the cable hatch and remove the Inverter power cable (the one with the lantern extension cord) press the
inverter cover tab and remove the cover. Ensure that the inverter's power switch is off. Then press the two tabs that
lock in the Inverter and release the Inverter and slide
NOTE: One of the Iwo flat pins on the bottom of the Inverter is wider than the other pin.
Connect the DC recharge cable onto these flat pins. Connect the plug of the DC recharge cable to a 12 volt DC
source.
CAUTION: When operating inverter from accessory plug, do not exceed 150 watts for long periods of time.
4.3.2

OPERATING TIME

Assuming a typical vehicle battery is the power source, a minimum operating time of 2 to 3 hours can be expected.
In most instances, 5 to 10 hours of operating time is achievable. However, Vector recommends that the operator
start the vehicle every 2 to 3 hours to recharge the battery system. This will guard against any unexpected shutdown
of the equipment and will ensure that there is always sufficient battery capacity to start the vehicle's engine. The
inverter will sound it's alarm when DC voltage drops to 10.6 volts.
CAUTION: Reverse polarity connection will result in damage to the inverter. THIS WILL VOID THE
WARRANTY.
If the inverter is connected to the incorrect polarity, the fuse will blow. If the unit does not function after
replacement of the fuse, the unit must be returned to Vector for repair. Repairs for this type of damage are not
covered by warranty.
CAUTION: Do not use with positive ground electrical systems (the majority of modern automobiles, RVs and
trucks are negative ground).
POWERING AN AC
4.4
The power inverter is equipped with a standard AC household-type receptacle and on/off switch. Plug the power
cord from the equipment you wish to operate into the AC outlet. The green LED will light to indicate that the unit
is functioning. Make sure the wattage rating of your equipment is within 200 watts. If so, turn on your equipment.
If an audible alarm sounds, the DC supply voltage is too low, if the inverter is connected to the main unit, then the
battery needs to be recharged if the inverter is connected to another DC source, then the voltage is too low because
of a discharged battery or the wiring gauge is not heavy enough.
WARNING ABOUT OUTLET STRIP USE: Remove appliance plug from outlet strip or turn off inverter before
working on the AC appliance. Multiple outlet power strips with switches and circuit breakers only interrupt power
to the "hot" receptacle terminals. The "neutral" terminals remain powered with respect to the "ground" terminals.
out of the mounting. (See Figure 4)
it
LOAD