Table of Contents
Advertisement
4.1 High Pressure Operation
• Ensure the Spray Lance with Vario Power Nozzle (No. 6) is attached
securely to the Spray Gun (No. 8).
• Set vario power nozzle to high pressure mode "+".
• Aim the lance towards the object to be cleaned
making sure the recommended working distance
is used for reference. Release the safety ratchet
on the Spray Gun and squeeze the trigger.
• Switch on the pressure washer (No. 2)
The pressurised water jet alone is capable of fulfilling most
cleaning tasks around the garden or on building work but
detergent and wash brush are advantageous when cleaning
vehicles or other paint finishes.
4.2 Low Pressure Operation with Detergent
• Dilute the detergent in a suitable container to the required concentrati-
on before using. (The correct dilution is dependent on the degree of
soiling of surface and is best determined by experience).
• Hang the Detergent Suction Tube (No. 1) in the Detergent Container.
• Set Vario Power Nozzle to low pressure mode "–".
Note: No detergent in high pressure mode
• Aim the Spray Gun towards the object to be clea-
ned, release the Safety Ratchet on the Spray Gun
and squeeze the trigger to apply the detergent to
the working area.
• Switch on the pressure washer (No. 2)
4.3 Low Pressure Operation with Brush
When cleaning surfaces with a grease contamination - typically car paint-
work that always has a greasy traffic film covering. Follow the
procedure of:
• Washing loose dirt away with the clean water high pressure spray.
• Apply the detergent in low pressure mode by removing the bayonet fit
spray lance and fitting the Wash Brush to the Spray Gun.
• Leave for 2-4 minutes for the detergent to have maximum effect.
11
Advertisement
Table of Contents
