Toshiba 20VL64 series Owner's Manual page 24

20VL64-en.book Page 24 Thursday, February 1, 2007 5:06 PM
Q
Why are there problems with text?
Good performance of text depends on a good
strong broadcast signal. This normally requires a
roof or loft aerial. If the text is unreadable or
garbled, check the aerial. Go to the main index
page of the text service and look for the User's
Guide. This will explain the basic operation of
text in some detail. If further information is
needed on how to use text, see the
Teletext" on page 21 for details.
Q
Why are there no text sub-pages?
There are none broadcast or they have not yet
loaded. Press to access. See
sub-page" on page 22 for details.
Q
Why are the four coloured text numbers visible
but no text?
Text has been selected whilst viewing an external
source i.e. DVD or VCR. No text will appear on
screen or a box may appear stating no
information is available. Select a broadcasting
channel and press
Q
Why are the colours wrong when a NTSC
source is played?
1. Connect the source via a SCART lead and
play.
2. Set Colour System in the Special menu as
Auto, NTSC3.58, or NTSC4.43.
3. Go to the Picture menu and adjust Tint. See
"Adjusting the picture quality" on page 17
for details.
Q
You can turn the VCR mode on in the OSD menu
to minimize or solve this problem.
1. Go to the Picture menu and press
highlight Picture Advanced Setting.
2. Press
Advanced Setting page and press
highlight VCR Mode.
"Using
3. Press
Picture Mode
Contrast
"To select a
Brightness
Colour
Sharpness
Tint
Picture Advanced Setting >
Note: The VCR Mode is available in TV position
0 and EXT modes selected only.
to access.
ENGLISH-24-
The picture from my VCR is poor, how can I
improve?
or OK to display the Picture
/ to select On.
Picture
1
53
32
32
Picture Advanced Setting
+0
Black Stretch
+0
Noise Reduction
Colour Temperature
VCR Mode
MENU OK EXIT
Picture Reset
MENU OK EXIT
to
to
Off
Off
Cool
On