Sony LBT-ZUX10D Operating Instructions Manual page 87

• If the system is brought directly from a cold to
a warm location or is placed in a very damp
room, moisture may condense on the lens
inside the unit, and cause the system to
malfunction. In this situation, remove the
disc, and leave the system turned on for about
an hour until the moisture evaporates.
• Do not place anything on top of the tape deck
as this may cause a malfunction.
On heat buildup
• Heat buildup on the unit during operation is
normal and is not a cause for alarm.
• Do not touch the cabinet if it has been used
continuously at a high volume because the
cabinet may have become hot.
• Do not obstruct the ventilation holes.
On the speaker system
Although the speakers are magnetically
shielded, the picture on a nearby TV may
become magnetically distorted. In this situation,
turn off the TV, wait 15 to 30 minutes, and turn
it back on. If there is no improvement, move the
speakers far away from the TV.
IMPORTANT NOTICE
Caution: If you leave a still video image
or on-screen display image displayed on
your TV for an extended period of time via
this system, you risk permanent damage to
your TV screen. Projection TVs are
especially susceptible to this.
Cleaning the cabinet
Clean this system with a soft cloth slightly
moistened with a mild detergent solution. Do
not use any type of abrasive pad, scouring
powder, or solvent, such as thinner, benzine, or
alcohol.
To prevent a tape from being
accidentally recorded over
Break off the cassette's overwrite protection tab
from side A or B as illustrated.
Break off the
casette tab
To reuse the tape for recording at a later time,
cover the broken tab with adhesive tape.
About a tape longer than 90 minutes
The use of the tape with more than 90 minutes
of play time is not recommended except for
long, continuous recording or playback.
Cleaning the tape heads
Use a dry- or wet-type cleaning cassette
(available separately) after every 10 hours of
use, before you start an important recording, or
after playing an old tape. Failure to clean the
tape heads can cause degraded sound quality or
an inability of the unit to record or play back
tapes. For details, refer to the instructions of the
cleaning cassette.
Demagnetizing the tape heads
Use a demagnetizing cassette (available
separately) after every 20 to 30 hours of use.
Failure to demagnetize the tape heads can cause
an increase in noise and a loss of high frequency
sound and an inability to completely erase tapes.
For details, refer to the instructions of the
demagnetizing cassette.
87 GB