Interfaces And Test Points; Introduction; Interfaces - Panasonic G600 Technical Manual

2

INTERFACES AND TEST POINTS

2.1

Introduction

This section provides details on connections between the RF and Baseband PCB and other interfaces on G600.
2.2

Interfaces

2.2.1 Baseband and RF
This details the 50-way connector between the RF and baseband PCB.
No. Signal Name
1 BAT TEMP
2 CHARGE ON
3 GND
4 TX AUDIO
5 RX AUDIO
6 GND
7 nADP SENSE
8 nHF SENSE
9 LO2SEL
10 BUZZ-
11 BUZZ+
12 SIM RST
13 SIM IO
14 SIM CLK
15 TX ON
16 PA ON
17 RF ON
18 RX ON1
19 RX ON2
20 nRADIO_MUTE
MCUK980101G8
Technical Guide
http://cxema.ru
Function
Battery Temperature
measurement signal
Charge control signal for
Dual Charger
TX AUDIO analogue
signal
RX AUDIO analogue
signal
Optional Adaptor
detection signal
Handsfree connection
sense signal
2nd Local Frequency
control signal
Buzzer control signal
Buzzer control signal
SIM Interface: Reset
signal
SIM Interface: I/O signal
SIM Interface: Clock
signal
Transmitter block power
control signal
PA power control signal
RF common block power
control signal
Receiver block power
control signal1
Receiver block power
control signal2
Radio Mute control signal
for Car
Section 2
2 - 1
INTERFACES AND TEST POINTS
Connection
ADIN3 of VEGA(10bitAD)
Extended I/O: Q(1)
AUXIN of VEGA
AUXOUT of VEGA
ADIN4 of VEGA(10bitAD)
IO(11) of GEMINI
TSPACT(4) of GEMINI
BUZZIN of Charge IC
REGFB of Charge IC
SIM RST of GEMlNI
SIM I/O of GEMINI
SIM CLK of GEMINI
TSPACT(10) of GEMINI
TSPACT(11) of GEMINI
TSPACT(5) of GEMINI
TSPACT(6) of GEMINI
TSPACT(7) of GEMINI
Extended I/O: Q(4)
Status
H:Charge On
L:Charge Off
L:HF connected
H:HF disconnected
L:RX 8 MON slot
H:TX slot
6V MAX
Depends on SIM Card
3.25/372=8736.56baud
3.25MHz clock
H:On, L: Off
H:On, L:Off
H:On, L: Off
H:On, L: Off
H:On, L:Off
L: Radio Mute
Hi – Z:Radio Un-Mute
Issue 1
Revision 0