Audio Output Connections - X-Digital System XDS-PRO Quick Start Manual

1.3 AUDIO OUTPUT CONNECTIONS

Once the XDS receiver is locked to the carrier you can verify audio functionality as
follows:
A. Verify audio reception
Initially the XDS receiver headphone output and all the audio ports are programmed to
receive the network‟s Test Channel.
Connect a set of headphones and verify you can hear the Test Channel.
To manually program the XDS receiver headphone to output the Test Channel:
o At the main screen with the network logo, press the SET key, then the left or
right arrows to reach Audio Ports. Press SET.
o Press the left or right arrows to reach Headphones. Press SET.
o Press the left or right arrows to reach Program. Press SET.
o Use the up and down arrows to find the network‟s Test Channel. Press
SET.
The Test Channel is intended to check receiver operation. It
does NOT prove that you can receive the network's
programming. To receive program audio, you must complete all
installation and Activation steps, including a fulltime internet
connection. Your XDS receiver must be connected to the
B. Verify audio ports
Your new XDS receiver may be delivered with a parts kit including four mating DB-9
connectors with shells.
The analog audio outputs for your services appear at the four DB-9 connectors on
the rear panel. Wiring pinouts are the same as on the older Starguide receivers:
AUDIO OUTPUT – DB9M
1226 R830000-1060
Rev H
internet at all times.
Pin Signal
1 L+
2 GND
3 -
4 GND
5 R+
XDS Pro Quick Start Guide
Signal Pin
L- 6
GND 7
- 8
R- 9
Page 5 of 11
1/11/2010