Internet Connection - Required - X-Digital System XDS-PRO Quick Start Manual

If this XDS receiver is designated to supply DC power to the LNB at your dish, you
can turn on the LNB voltage on the XDS receiver front panel menu as follows:
Make sure your downlink LNB is connected to the XDS receiver
Apply AC power to the receiver
o From the main screen with the network logo, press the SET key, then press
the left or right arrows to reach Setup. Press SET.
o Press the left or right arrows to reach Tuner. Press SET.
o Press the left or right arrows to reach LNBV, Press SET and turn the LNB
Voltage on.
If the front panel of your XDS receiver displays flashing red
lights, this indicates all Activation and Installation steps have
not been completed and/or your XDS receiver is not connected
to the internet. All Activation and Installation steps, including
your internet connection, must be completed or you will NOT
receive the network's programming. Your XDS receiver must be
connected to the internet at all times.

1.2 INTERNET CONNECTION - REQUIRED

This new XDS receiver requires connection to an always-on internet pathway. The
internet pathway is used by the network to troubleshoot remotely, send audio or text
content to your receiver‟s storage, send commercial playback schedules, retrieve as-
played logs of commercials inserted by the receiver, and more.
Your XDS receiver is delivered with a 20-foot Category 5 data patch cord wired "straight
through" (not crossover) for connection to your network‟s hub or switch.
A. Connect the XDS Receiver to your network
If you elect to place your XDS receiver in your local network "inside" your
firewall, connect your network cable to one of the receiver‟s LAN ports. The
receiver is set by default to obtain a dynamic IP address, also called a "DHCP
address", from your network‟s DHCP server. If there is no DHCP server or you
elect to assign a static IP address, you can do it as follows:
Assigning a Static IP address to a LAN Port:
o At the main screen with the network logo, press the SET key, then the left or
right arrow keys to reach Setup. Press SET.
1226 R830000-1060
Rev H
XDS Pro Quick Start Guide
Page 3 of 11
1/11/2010