Advertisement
Installation
1
Install mounting track inside the
wall cavity using a minimum
of two #10 (M5) self-tapping
flathead screws per section. If
required, cut mounting track to
desired length.
Snap in LED fixture
4
Snap the first LED fixture into the
mounting track.
Electrical Connections
Connect the leader cable to the power source and dimmer.
OPTIONAL: If dimming is not used, cap the purple and gray wires with UL approved wire connectors. Do not connect the
wires together.
Leader cable to LED fixture
Black (+)
120-277V
White (-)
AC Line
Green (ground)
2
Assemble the LED fixture and
the bracket by pressing them
together.
5
Continue placing fixtures, being
sure to join plugs male to female.
Attach jumper cables as needed
to work around any obstacles,
corners or separations.
Gray (-0-10V)
Dimmer
Blue (+0-10V)
Orient plugs male to female
Leader cable to LED fixture
240 VAC
Line
Leader cable
3
Connect the leader cable to the
male plug on the first LED fixture.
6
Place end cap from leader cable
on the electrical plug of the last
fixture in the run.
Brown (+)
Gray (-0-10V)
Blue (-)
Black (+0-10V)
Green/yellow
(ground)
Dimmer
Advertisement
