Sony MZ-R91 Service Manual page 13

5. The display changes a shown below each time the jog key on
[DISPLAY]
the set is turned up or
mander is pressed.
• Address & Adjusted Value Display
LCD display
C 6 8 S 0 1
011
address
mode number
• Jitter Value & Adjusted Value Display
LCD display
0 F F J 0 1
011
jitter value
mode number
• Block Error Value & Adjusted Value Display
LCD display
0 6 3 B 0 1
011
block error value
mode number
• ADIP Error Value & Adjusted Value Display
LCD display
0 5 9 A 0 1
011
ADIP error value
mode number
• Item Title Display
LCD display
L r e f P w 0 1
011
item title
mode number
However in the power mode (mode number 700's), only the
power adjustment value is displayed.
• Power Supply Adjusted Value
LCD display
A D 8 5
731
fixed display
mode number
6. Quit the manual mode, and press
mode (display check mode).
key on the remote com-
adjusted value
adjusted value
adjusted value
adjusted value
adjusted value
adjusted value
key to return to the test
x
– 13 –
[Overall Adjustment Mode]
Mode to adjust the servo automatically in all items.
Normally, automatic adjustment is executed in this mode at the
repair.
Adjust the CD first, when performing adjustment.
• Configuration of overall adjustment
> key . key
Title
display
N key
protect switch ON
x key
x key
protect switch OFF
key
x
key
x
[Test mode $display check mode%]
For further information, refer to the Section 5 Electrical Adjust-
ment. (See page 18)
CD overall
adjusting
All item NG item exists
OK or x key
CD overall
adjustment
NG
CD overall
adjustment
OK
key
>
MO overall
adjusting
NG item exists
or x key
MO overall
adjustment
NG
MO overall
adjustment
OK