Engine Oil Replacement - Generic TR 125 Service Manual

Expected Inspection
1 Ignition system -- perform maintenance inspection on obvious and continuous ignition malfunctions,
engine on fire, overheated back burning and others.
2 Carbon deposit removal -- obvious underpowered, get rid of carbon deposit at cylinder head, piston head
and air exhaust system.
3 Piston and cylinder -- when cylinder is over worn or stuck, please replace it.
Please go to your local Qianjiang Motorcycle dealer periodically for inspection and adjustment to keep your
vehicle in best conditions.
In above table, monthly 1000km travel is employed as reference.
I— Inspect A—Adjust
Note: 1. "*" for items involved in exhaust gas, which meets regulations of
Normal maintenance shall be performed according to specifications on the user's manual; unauthorized repair
and adjustment are forbidden. We will not be responsible for the results.
2. You shall clean more frequently the air cleaner to extend its service life when your motorcycle is used
on sand-gravel roads or in severely polluted environment.
3. More frequent servicing may be required when the motorcycle is often driven at high speed or travels a
long distance.
Engine Oil/Filter
Engine oil level
*Attention
• Motorcycle shall stand on the flat
ground while checking engine oil level.
•Inspect engine oil level when the engine
has run for 2~3mintues or stopped for
2~3minutes.
Check engine oil level
When the engine oil level sensor alarms, refill engine oil to its upper limit.

Engine oil replacement

* Attention
When the engine is warmed up, replace
engine oil. The oil can flow out easily.
Shut down engine.
Screw off the drain plug at the bottom of crankcase to drain engine oil.
When the engine oil is completely drained, put back cleaned drain plug and sealing ring.
Refill engine oil to specified level.
Engine oil volume: 1.0-1.2L
R—Replace C—Clean L—Lubricate
- 18 -
national environmental
Oil adding hole
Oil draining hole
protection.