Generic TR 125 Service Manual page 10

Pay special attention to the key fitting position before disassembly. The components that are not used any more
shall be replaced on time before disassembly.
Length of bolts and screws are different for assembly
components and protecting plates. They shall be installed at correct positions. If confused, just put the bolt in
the hole and see if it matches.
Fill lubricating grease into the groove during oil seal installation. Check
if the oil seal is smooth and if there is any damage to it.
Installation of rubber hose (fuel, vacuum, or coolant):
insert its end into bottom of connector so that there is
enough room for the hose clamp to grip the connector.
Install the rubber or plastic dust cover back to its
originally designed position
- 5 -